Connecting & Configuring via USB-C
You can configure the Air Pro 2 through its USB-C interface with a serial monitor or terminal emulator. The USB-C service port sits inside the housing — open the enclosure to access it. The Sensorbee reference terminal is Tera Term — see the Tera Term installation guide for setup instructions.
Connection settings
Configure your terminal's serial connection with:
| Setting | Value |
|---|---|
| Baud rate | 9600 bps |
| Data bits | 8 |
| Parity | None |
| Stop bits | 1 |
Once the serial connection is established, the main menu appears automatically after the unit boots.
In this section
- ·Main Menu
- ·Polling Interval Menu
- ·Firmware Update Menu
- ·System Settings Menu
- ·Modbus Settings Menu
- ·Reset Menu